Use on properly prepared and cleaned coated and uncoated Exterior surfaces. Protection for Wood, Vinyl, Aluminum, Fiber Cement Siding, Metals, Brick, Masonry, Stucco, Steel and Fences.  Do not use on floors.

• Use on properly prepared and cleaned coated and uncoated Exterior surfaces. Countersink nailheads, fill and sand smooth. Remove rust, loose or peeling paint. Repair imperfections and sand smooth.
• Wash off dirt, grease and chalk with detergent and/or powerwash. Remove mildew stains with a mildew stain removing product.
• Clean and sand new or weathered wood. Scuff sand or degloss smooth or glossy surfaces.
• Scuff sand or etch metals. Rinse and allow to dry.
• Caulk windows, doors and other openings.
• Allow new stucco, plaster and masonry to cure for 30 days before painting.
• Use BEHR MARQUEE paint as a primer for repaired or uncoated surfaces, including woods that contain tannins and heavily stained areas (two primer coats required for redwood and cedar).
• Lock in stains with the first primer coat; if necessary, apply a second primer coat of BEHR MARQUEE.
• For drastic colour changes or when applying deep colours denoted with a dagger (†) on the colour chip, apply a tinted primer coat of BEHR MARQUEE, if needed.

• Apply product on dry substrates when air and surface temperatures are between 2°-32°C and will remain between 2°-32°C for at least 4 hours after applying.
• Allow paint film to dry for at least 60 minutes prior to rain showers when temperatures are between 15°-21° C and 60-70% relative humidity. Lower temperatures, higher humidity or deep colours may increase dry time and/or rain resistance time.
• Stir paint occasionally. Intermix containers of same product to ensure colour and sheen uniformity.
• On semi-smooth surfaces, use a high quality 10-13 mm nap roller cover, nylon/polyester brush or an airless sprayer (.015 -.021" spray tip, 60 mesh filter).
• On rough surfaces, use a high quality 19-25 mm nap roller cover.
• Do not thin if using a roller or brush; however, if using a sprayer and thinning is required, thin with water at a rate of no more than 250 mL per 3.79 L
• Certain colours may require more than one coat for complete hide.
• On heavy stains and woods that contain tannins, allow 12-16 hours of dry time between coats.
• After 4 weeks, cured paint film may be cleaned with a mild, non-abrasive liquid detergent. Dry paint film is mildew resistant.
• When applying to vinyl, colour choice must be the same colour or lighter than the existing colour.
• Do not use on floors.

• For disposal of empty containers, unused paint and soiled rags, contact your household refuse collection service.