BEHR PREMIUM^® Protector & Waterproofer No. 980

Where to UseBlank space if empty.

Horizontal and Vertical uncoated Concrete and Masonry surfaces such as: Concrete Block, Pavers, Stucco, Brick, Unglazed Tiles, Exposed Aggregate Concrete, Sandstone and Slate. Not recommended for use on areas subject to hydrostatic pressure such as basement walls or floors.

Usage SummaryBlank space if empty.

PreparationBlank space if empty.

The following steps are recommended for best results.

• New concrete must cure for a minimum of 30 days.
• Remove old coating or sealer, if present, using a product such as BEHR PREMIUM^® CONCRETE & MASONRY PAINT STRIPPER N0. 992. Follow all label instructions.
• For proper penetration and adhesion, use a product such as BEHR PREMIUM^® CONCRETE & MASONRY CLEANER & ETCHER NO. 991 to clean and etch the surface. Follow all label instructions.
• TEST: Sprinkle a few drops of water onto the surface. If water is quickly absorbed, the surface is ready. If not absorbed, re-etch.

ApplicationBlank space if empty.

• DO NOT THIN. Stir or shake before applying.
• Use product when temperature is between 10-32°C.
• Apply until saturated by brush, roller or garden sprayer to a dry surface.
• Remove any puddles by spreading product to drier areas or by wiping up excess with a clean cloth.
• On vertical surfaces, apply from the bottom up and saturate well.

Dry TimeBlank space if empty.

• Once dried, rough, vertical surfaces may be coated with an oil or latex-based paint or primer. Follow all label instructions. Do not paint horizontal surfaces after applying this product.

DisposalBlank space if empty.

• Clean all equipment immediately with warm, soapy water.
• Properly dispose of all soiled rags and protect unused product from freezing.
• For disposal of empty containers and unused paint, contact your household refuse collection service.

Behr Process Corporation warrants to you, the original residential consumer purchaser, the performance of this product as described on this label for 10 years on vertical and horizontal surfaces, from the date of purchase. THIS WARRANTY IS NOT VALID WHEN THE PRODUCT IS NOT PROPERLY APPLIED TO A PROPERLY PREPARED SURFACE OR CARED FOR IN ACCORDANCE WITH THE LABEL DIRECTIONS. This warranty is not transferable. If this product is found not to perform as specified on the label during the warranty period, Behr Process Corporation will, at its option and upon presentation of proof-of-purchase (the original receipt), either furnish an equivalent amount of new product or refund the original purchase price of this product to you. This warranty excludes (1) labor and costs of labor for the application or removal of any product, and (2) any incidental or consequential damages, whether based on breach of express or implied warranty, negligence, strict liability or any other legal theory. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights, which vary from state to state. Note to residents of the State of New Jersey:  The provisions of this warranty, including its limitations, are intended to apply to the fullest extent permitted by the laws of the State of New Jersey. To obtain warranty service, call 1-800-854-0133. Behr Process Corporation reserves the right to inspect any and all application of the product prior to processing your claim made under this warranty.